Specification

Performance specs

Datasheet for Reach RS+ [PDF, 1,5 MB]

Mechanical specs

File name	Download link
Reach RS/RS+ general drawing	reachrs-drawing [PDF, 451 KB]
Reach RS/RS+ 3D model in STEP format	reach-rs-rsplus [STEP, 8.34 MB]
Reach RS/RS+ 3D model in IGES format	reach-rs-rsplus [IGES, 10.6 MB]
Pattern of mounting holes for Reach RS/RS+ damping platform	reachrs-damping-platform [PDF, 95 KB]

Antenna height specs

GNSS antennas are precisely calibrated through the National Geodetic Survey measurements. These calibrations define the antenna phase centre (APC).

In Emlid Flow and Emlid Studio, you don’t need to worry about APC values, as the software automatically applies the correct phase-centre offset. You only need to enter the height measured from the ground to the antenna reference point (ARP) on the bottom of the receiver.

For Reach RS/RS+, the distance between the ARP and the antenna center is 65 mm, as shown in the device drawing. Emlid Flow applies the phase-centre offset automatically, so entering the pole or tripod height to the ARP is all that’s required for accurate measurements.

Electrical specs

Antenna reference point (ARP) of Reach RS/RS+ is situated on the bottom of the receiver. For Reach RS/RS+, the distance between the ARP and GNSS antenna is 65 mm.

Reach RS+ External bottom connector pinout [PDF, 116 KB]

Extension cables specs

Cable type	Download link
Without second connector 2m	without-connector [PDF, 135 KB]
DB9F 2m	DB9F [PDF, 139 KB]
DB9 2m	DB9 [PDF, 139 KB]