Skip to main content

Specification

Overview​

Performance specs​

Datasheet for Reach RX2 [PDF, 6 MB]

Mechanical specs​

File nameDownload link
Reach RX2 general drawingreach-rx2-drawing [PDF, 807 KB]
Reach RX2 3D model in STEP formatreach-rx2-step-model [STEP, 38.6 MB]
Reach RX2 3D model in IGES formatreach-rx2-iges-model [IGES, 43.7 MB]

Antenna height specs​

GNSS antennas are precisely calibrated through the National Geodetic Survey measurements. These calibrations define the antenna phase centre (APC).

In Emlid Flow and Emlid Studio, you don’t need to worry about APC values, as the software automatically applies the correct phase-centre offset. You only need to enter the height measured from the ground to the antenna reference point (ARP) on the bottom of the receiver.

The phase center offsets of Reach RX2 L1 and L2 are 147.1 mm and 149.0 mm, respectively.