edit

LED status

LED functionality is available with ReachView version 2.7.0 and newer

Reach M+ LED indicators

Reach M+ has three LEDs, which are used as status indicators for three different parts of the system:

System part Indicator
Power
Network
Stat

Power LED

LED state Demo
Reach M+ is OFF
Normal operation

Network LED

During boot, Reach M+ enters a network scan state in which it will try to connect to any known Wi-Fi networks it can find. This might result in connecting to a previously added network or creating its own hotspot.

LED state Demo
Scanning
Client Wi-fi mode
Hotspot mode

The Network LED behavior changes every time you change the Wi-Fi mode via ReachView. It will reflect turning hotspot on, scanning and connecting to existing wireless networks.

Stat LED

Stat LED is used to display ReachView status.

LED state Demo
Time sync
Normal operation
Point collection
Internal error

Time sync

After network configuration is done, green LED will start blinking. It is shown during time sync.

Attention

The app will not launch until the time sync is complete. Internet connection allows this to happen automatically, but in hotspot mode Reach requires a connected antenna with some satellite visibility.

LED Behavior

The table below demonstrates possible flash patterns describing various states of the receiver.

Reach State Demo




OFF





Loading





Time sync





Network scan





App running, client Wi-Fi mode





App running, hotspot mode





Point collection
assuming the device is in hotspot mode





Internal error
assuming the device is in hotspot mode