edit

RC input

PPM

ppm To be used in autopilot applications Navio needs to decode RC input. Measuring each PWM channel requires multiple connectors and plenty of wires. PPM sum signal combines all PWMs from the receiver in one sequence, which could be transferred over single wire.

Most modern receivers output PPM, but if you have an older RC gear with only PWM output an encoder can be used. For the S.Bus receivers we are preparing a separate driver, however a S.Bus to PPM converter exists.

In case you want to run the code on Raspberry Pi without Navio please note, GPIOs on Raspberry Pi are not 5V tolerant. A divider is required to lower the voltage of the signal. Navio has a built-in voltage divider in PPM Input that lowers the voltage level from 5V to 3.3V. If you connect a 3.3V PPM device (which is rare) to Navio PPM will not be detected. Navio+ has a logic level converter and you can connect both 3.3V and 5V PPM.

We use pigpio library that is capable of sampling GPIO with 1 microsecond resolution over the DMA. The application makes time marks of all edges both rising and falling and measures the delta time between them. If that time is the size of a sync pause, then it is the start of the cycle. After the start of the cycle it measures pulse lengths and stores them.

The acquired PWM values can be used in an application or transferred to the Navio’s onboard PWM generator as it is shown in the video.

PPM input example

Example code is available in our GitHub repository, if you haven't previously downloaded it, visit Navio examples setup page.

The example requires pigpio library. To install it on Raspebrry Pi:

sudo apt-get update
sudo apt-get install pigpio

Use this library with caution.

To compile and and run the example navigate to the directory with it, then run make and execute the compiled binary:

cd C++/Examples/PPM-decoder
make
sudo ./PPM

Now you can connect PPM output from your RC receiver to the PPM Input pin on Navio and connect servos to RC Output channels 1-8 on Navio. Servo rail power (BEC) also must be connected. Channel values sent by remote controller will be decoded and passed to servos as seen in the video.